Secware_Tech6

It looks like you have wired it double pole but configured your detector for eol use. Change the jumpers for non eol use and you should be ok

No you cant you will need a 12v detector. Honeywell do a 12v non latching base for their detectors

Could you upload a picture of the wiring, the dip switch/jumpers and what panel you are using please

It does sound like the pirs have no power. On a pir if there is no power they will be in alarm. Do the walk test less illuminate on the pirs

Its not a programmable option on the smaller panels

You could use port forwards but I recommend vlans or vpns. Ideally use something like a draytek router and link all sites together via vpn. Alternatively you could look at smoothwall units or openvpn This is a IT solution as I wouldn't recommend passing security information over your wan with out strong encrytion.

On that panel id link them out.

Any of the premiers could do that but u will need a few modules. Have a look at the Honeywell flex this will do as you need and has app support. I wouldn't recommend sms alerts unless using a gsm module.

The active beams come with pole mount brackets so you can concrete in the pole and attach. No you cannot get mirrors designed for the purpose, while the theory is sound it would be a difficult to setup and maintain.

It will need a repair if the lcd has failed

When it triggers what is it reporting as the cause?

So are the pirs still all in alarm?

Id say a cqr bell unit but everybody has a personal preference

Id advise a siemens eline dt in that situation. Its the best pet sensor I've personally tested. But the only 200% way is to use perimeter protection, ie vibs and contacts

You shouldn't have more than one device per circuit. Eol Is only more secure if the cable is attacked.

Could be but id be surprised. First I check day mode current Dc supply voltage at the detectors And ac ripple on the cabling What do you have connected to the panel? If you could post the readings above please

What is the environment your fitting it?

As you have rasied a ticket it will be discussed here to. But as i dont have that info just yet was it all ordered together or are you adding older kit to new gear?

Vibs will be fine but you need to factor in the reduced real detection area on plastic. As with all perimiter protection has the same same fa causes. If fitted incorrectly. Most common on plastic doors and windows is to have too few units covering a too large an area

The hkc system I similar to id and will work on the cabling in place, probably. The castle id modules are no longer available.

Yes you will need to remove the shock detector then commission the pir in its place

1 yes you are correct you only need links on unused inputs 2 the alarm will sound when you power it up ie when the mains is connected 3 yes that is for the optima

Have you tested your battery isn't reversed charged? Also if you remove all 12v out on the panel does it still blow?

If you add the portal you can use the circuits. You only need a Rio for hard wired. You can use upto 20 circuits of either type in total

Yes that's a short run