Secware_Tech6

Let us know your account name and we will reset it manually and test.

The master blaster is purly a sounder. I would suggest a basic panel to control it. say a honeywell optima gen4, then a detector of your choice. Tech

Do you mean a wireles phone addition?

The powermax plus has 2 conventional zone input on the rear of the case, so yes you can.

i think you have an sd1 manual and you have an sd1+? you will need to enter the code rather than press / hold enter to get to the menu

as above id recommend a 16 ohm unit.

all our rf gear is 868 unless marked otherwise, ie 433 etc

The range should be fine, but wireless needs to be tested on site. Sounder wise id have a look at the honeywell ag6 or any of the texecom sounders

Sounds like you have a tamper on the bell, have you ensured all switches are closed?

an external warning? Well the simplest would be a mains relay from the light and an external sounder and power supply. But id recommend the gjd system, or an full control panel would be better. Depends on their budget and needs really.

you can send it back to us for replacement. You didnt remove the keypad frm the panel by mistake instead of the sounder did you?

its not 180 deg, i dont know of a single head pro unit that is. Its usually only the low qualioty stuff that is. but it is 12v, with adjustable times etc Have a look at the product page download the data sheet

12v dc? id so the only unit that will do 180 degs is the voltek twin head. But this doesnt have adjustable times etc. Apart from the opal elite (gjd) none have a programmable time this is usually done by the controller

Try this It will be in ythe install manual for your panel too. You may need to alter the resistor values to match your panel.

Sounds like it is. Id request and RMA and we will replace the unit

Not that we can make public. The engineer code provides integrity of your system, it should not be 'forgotton'. James

Id do the mains first as its easier to connect that quickly, ie push fuse in. A clean power up is essential. Howver as soon as possible the nattery shoudl be connected. SOme panels need the battery to operate the protective device (ie the lower voltage fuse) if you have a wiring fault you can end up popping the panel with out the battery connected. To be 100% safe fully charge the battery from the panel with nothing connect to the pnale (other than the mains and the battery)

Please see attahced basic diagram

if you let us know your day mode and alarm currents i will do the calcs for you. Support

no its not available on the site. if you let us know the orderr number we will send you one. Support

id assume you havnt got the zones configured correctly how are they setup currently.

yes you right however you will need to tamper the other detectors

not a full alarm no

when say gsm speech dialler are wanting to transmit voice over it or alarm data?

what do you have a single device on a zone. and what is the eol configuration?