Secware_Tech6

id imagine you dont hve the right resistors in the relay

its programmed for engineer and anticode reset. It needs reprogramming to put remove that and set it to user reset

id take a look at the honeywell 7450

It is a question of customer preference,

It will be configured for grade 3 mode. This does not permit a 4 digit code due to the lower security level of a 4 digit code on grade 3 systems

Are you 100% certain there is power getting into the panel. Is the transformer etc ok?

Normally the axis camera would be programmed to store images on your nas drive itself.

I dont understand. DO you mean renumber the circuit?

Or power the devices from a 12v PSU ie http://www.securitywarehouse.co.uk/catalog/index.php?main_page=product_info&products_id=3485

Have you enabled the status leds?

You do not need the relay on that panel. The relay is for panels that do not support comms

We will need to split the download out from that order and mark it as ready for download. Its not possible to download a file unless it is on its own

ID prove the panel first before deciding its at fault. If you discconect all wiring and put the relevant resistors accross the circuits are they still in fault.

If your planning on using this to activate the alarm i would advise against it. But you could use an optex or takex infrared beam instead on your panel

Does the fuse blow when the battery leads are disconnected from the pcb?

if i recall those connections are marked on the pcb during manufacture. But you wont find the other end having s1 s2 etc as they will only have s.

As above you may have a data issue. Tryu connecting just one keypad on a short temporary length of cable at the control panel

Ill need a little more info. You will need to use an inhibited zone for your hallway sensor if you want it on delay after opening the entry door

Yes you need a non powered sensor such as the aritech units. However you will need an analyser to use such detectors with your panel

The masterblaster probably doesnt have a permanent 12v supply. Any dialler will need this but the trigger feed will be at the blaster.

Either above or a dualtech like the optex mx40 or honeywell 7550

Id have to check the docs but that will be about right. It wont be anywhere near 1A You will need to series your tamper returns and HO-ve and not connect the bell trigger on the second unit

Sure whats your order number ill look into it

HI 1. Sales would be best for that. 2. Not to close to distort. Just practice a few times to get the ideal distance and volume for your voice. Id say about 15cm 3. The only way to do this is to walk test each correctly and adjust

You have chnaged the code from default to something else (miskeyed perhaps) A factory default will if done correctly put this back to how it was out of the box