Secware_Tech6

I don't know what you mean by a call sender? Bellbox use a cqr multibox best sounder currently imo

Have you followed the rf enroll procedure fully?

If it's on it's pwn circuit then use the non latching base.

I'd recommend the siemens eline Pir range and knight door contacts

The 9930 is a keypad not a control panel. You need to know what radio Rx system you have.

A master blaster would work in this situation but I'd advise getting someone to do it. Our equipment is professional gear and not designed for diy use

As above if you don't need cams integrated into the same app then the dimension is a good panel

No you can't on a basic system like this, you would need a more flexible siemens spc or Honeywell dimension

If authorised pro installer then the hkc has the best app support.

Yes they will you can adjust the beam interrupt time. What do you mean by phone card dialler?

The only control panel that I know that can easily do that is the siemens spc range.

Iirc the 6 wire keypad is no longer available. I would advise a replacement as id guess yours is well over 10 years old.

No it has to show. What if it was a rear door and had been left open. Its only reporting it is activating it does not affect the exit procedure

Non of our equipment is designed for diy installation. For that you need to use b&q etc as these supply the low security easy fit products

Use an enersys 2.8 but it does depend on the system load. What is your standby current on the system?

You need a panel that supports groups such as the galaxy dimension or siemens spc. Id recommend a cqr sounder and siemens pirs

Ok yes the aerial will help bit you may need some more receivers

Are you just using the internal aerials? What's the distances and environment

The detector manual will show how. You need to remove the eol jumpers

It looks like you have wired it double pole but configured your detector for eol use. Change the jumpers for non eol use and you should be ok

No you cant you will need a 12v detector. Honeywell do a 12v non latching base for their detectors

Could you upload a picture of the wiring, the dip switch/jumpers and what panel you are using please

It does sound like the pirs have no power. On a pir if there is no power they will be in alarm. Do the walk test less illuminate on the pirs

Its not a programmable option on the smaller panels

You could use port forwards but I recommend vlans or vpns. Ideally use something like a draytek router and link all sites together via vpn. Alternatively you could look at smoothwall units or openvpn This is a IT solution as I wouldn't recommend passing security information over your wan with out strong encrytion.