Secware_Tech6

Yes but iirc this already built into it.

How is the unit connected?

No I'm afraid not

Depends on your system load. What's its standby current?

Record remotely? The sw units can via the cms software, look in the user options.

id say you have a faulty keypad then, let returns know ur order number etc so it can be replaced

I'd verify the switch is closing and doesnt need an adjustment. Does it clear if you push the switch manually

Is this a keypad tamper and not a tamper in the panel etc?

The install manual for your panel will show the wiring diagrams for eol

Use the right cable

Assuming you have a spare wired circuit then yes, you want the non latching version

Does it have to be a texecom panel, it's seen as a bit diy/electricians choice not a pro panel?

It does not meet en50131. What sort of panel are you looking for

No the logic 6 is a stand alone unit. Have a look at the accenta units instead. You can add a prox reader to these if requires

Look at the Siemens eline. Dt etc is not normally required

Have a look at the Siemens spc range

Grade 3 is a higher security level Links are for custom programming of functions The gd is the better panel Yes the pirs will be fine

No the keypad isn't wireless

If no one says hello then have a look on the nsi website for an approved firm

It will have a tamper alarm. Advise you get an new maintainer to support it for you

They come with the key pads.

Where in the country are u?

What's a jenco board?

Sounds like it isn't communicating with the panel. Check the connections. Is there only 1 keypad on it? Also what's the day mode current?

Have a look at the Siemens spc range