How do I omit a zone on a Scantronic 9651 with 9941 keypad?

[secware3]

Hi how do I omit a zone on key a control pad 9651 /9941?

[Secware_Tech6]

Omitting Zones Your system may be programmed so that you can omit individual detectors.

Ask your Installer which zones can be omitted.

To omit a zone:

1. Key in your access code or present a tag and press X. The display shows: Omit Zone?

2. Press the number of the zone you want to omit (for example, key in 07 to omit zone 7).

3. Press Y. The sounder gives a double beep and the display shows the zone number followed by an "o": Note: Omit Zone? Omit Zone 07o If the display shows a “x” after the zone number then you cannot omit that zone. To omit further zones repeat steps 2 and 3.

4. Press X to finish.

To set the system with an omitted zone:

5. Key in your access code (or present a tag) and press a Level key..

6. The control unit gives an error tone and the display shows (for example): A:Omit Zone 07?

7. Press Y. If necessary, press Y again for each omitted zone shown on the display. (If you wish to escape press X.) After you press Y for the final omitted zone the control unit starts to set.