Hi

Could you tell me what passive would replace this one as it has 3 extra connections to the normal 6.

These are marked C+ , E- , and FTA.

There is a wire looped from the power minus connection to the FTA connection and a brown wire in the cable connected to the C+ connection.

What is the purpose of these extra connections ?

The reason for replacement is that this passive leaves the led indicator on permanently which doesn't seem correct.

I have always used risco quads in my own setup and they seem very reliable.

Would one of these fit the bill ?

The panel is a Scantronic 9800.

Hoping someone can point me in the right direction for a replacement.

 

Thanks in advance  Kevin

Without Knowing the sensor its hard to say

Id suggest that FTA is first to alarm. THis would suggest there is more than 1 sensor on the zone and the device is latching

E- could be LED Enable -

C+ i dont know.

 

Risco quads are good units, i personally wouldnt always spec a quad in a domestic, unless there was a reason. Usually go for a good dual edge PIR

Just noticed you put the sensor in the title. Sorry about that

 

C+ is the Latch Freeze inout

E- is the LED enable

FTA is the first to alarm link if linking multiple detectors.

Hi Kevin,

 

I hope this helps you a little more, the MEQ12 or the KX15DQ  is the nearest ones to the old Magnum pir's

 

Regards

Elaine