Installed a new Galaxy Flex 20 with mk8 keypad and a couple of RF zones. Had some previous issue with the tampers and low battery in a few PIRs but that has been sorted now. I have a new 7.2Ah battery fully charged.

Problem is when I set the alarm I get this "ALERT-BATT LOW", ent=CONTINUE SET on the panel, and then after pressing enter "ALERT-FAULT RST" ent=CONTINUE SET. So I can set the system by ignoring these error, but what are these errors coming from and how to get rid of them?

 

Have a look in the event log to start with. Post what's in there. 

After overriding the faults and setting the system, the log (22) writes:

• OVERRIDE
• +BEGIN SETUSR 23
• FULL SET USR 23

 

There should be a device listed as well showing which one or ones are in low battery. You can also check from the engineer menu on a per device basis

Actually now, after it's been shut down for a few weeks, after starting it up it all seem to work fine. I don't get these errors any longer. Very strange because nothing is changed and I did shut it down several times before... anyway, all good now it seems. 

I have the same issue with galaxy dimensions while setting an 'ALERT-FAULT-RST keeps on popping in one of the groups. After clicking CONT'  the system allow setting to proceed.

How do i solve this issue?

Edited February 17, 20215 yr by Jimgu
Misspell

Is the system healthy?

Have you acknowledged the warning in the relevant group with a manager code? 

Not  yet, how do i do this. Kindly help

Enter the manager code then enter, scroll through the events and press enter. That should put you into manager menu. Then select timed set and press enter. Arm the system in the usual way, but do complete the set. 

Well understood, thank you.