Security Lighting

customer has a voltek security light system. 1803 controller with 2 sensors and an internal alert. the sensors work, triggering the internal alarm, but there is no output for the 2 floodlights. i have checked the 20mm fuse to the immediate right of the 240V output terminals and it's good.i suspect that the 1803 is faultybut would like a 2nd opinion before buying a replacement.

I’ve purchase some exterior lights auraglow exterior wall , my brother also purchase a zone module and pir sensors from you , but I’m not sure if these lights will be compatible, also I’ve got 4 lights at front 2 in alley way , how many pir sensor would I need and also are they all easy to set up GJD Equipment: 1 x GJD DygiZone Digital 4 Zone Lighting Controller & Enunciator 8 x GJD Mini Opal External PIR (Black)

Hi there, I am looking for a solution if possible for when my customers intruder alarm activates for it to be able to switch on external floodlights? Is this possible with your single control zone unit ie 1803 range or similar. It will be attached to a Texecom Veritas Excel Intruder panel , possibly connected to the bell -ve trigger.

Dear Sir or Madam I want advice and information on products that you might have that would suit my needs. I want to automatically switch on my driveway lights when, after dark, a pedestrian or vehicle comes into the gateway or starts up the driveway upon leaving the house, so I will need two sensors. I would like to use break-beam technology rather than PIR so that I can have the beam approximately 75 to 100 centimetres off the ground where it will not be triggered by dogs etc. I expect that when the beam is broken a signal will be sent to switching circuitry inside the house which will turn on the lights. The lights should stay on for about 5 minutes before turning off a…