Hi, wonder if anyone can help. I have a Pyronix sterling10 Panel and RKP and i am changing the bell box for a Gardtec Eurosec XS3D (the triangular one) i have wiring diagrams for both but i an unsure which wires go to where ...Could anyone enlightem me?? ...ie i.e  ST- on bell box to  NO on panel, TMPR on bellbox to BElLL- on panel etc..

Please help... regards//Martin.

Your best bet is to list what connections you have and then someone here will translate them

Hi,

 

The Terminals on the sterling 10 Panel are as follows :-.

 

STROBE ( NC, C, NO)

Bell ( NC, C, NO)

BT

BELL+

BELL-

 

The terminals for the Gardtec Eurosec XS3D are below.

 

ST-

TMPR

S-

12V

0V

 

 

I ave also sent your tech dept an Email but posted on here too as it might help others??

Martin

You will need to wire a negative from Bell- to NO on both the Strobe and the Bell relay connections/

Then use the Common on both © as the trigger. so

 

Panel                Bell

Strobe C          ST-

Bell C              S-

BT                  TMPR

Bell+              12v

BEll-              0v