Jump to content
Security Warehouse Support Forum

Visonic Powermaster 10 - Do I Need To Factory Reset?


mt123789

Recommended Posts

Hi,

 

I am experiencing odd behaviour with a Visonic Powermaster 10.  Due to a planned extended power cut, the panel was unplugged for 24 hours, during which time the battery went flat.  The panel was reconnected to the mains when the power returned and it eventually booted back up.  Since then it has suffered 3 false alarms from separate PIRs. 

 

Should I do a factory reset to try to resolve the issues?  If so, is the only option a hardware reset?  When I open the back of the panel I can see three pins marked DEF and 3 marked RST.  Which pins should I jumper please?

 

Thanks in advance for any assistance.

 

Mark.

Link to comment
Share on other sites

Ok. Fair comment regarding defaulting. I've found the option for software reset.

 

In each instance, the PIRs triggered a normal alarm event rather than a tamper. Each alarm was caused by a different PIR. First two were on a warm day, so I'd assumed it was related to weather. The third alarm was from a PIR on the front of the house, which doesn't get sun, and was on a cool day. All alarms happened after the system had been set Away for approximately 30 minutes.

 

No unrelated troubles; missing reports or low batteries are being reported.

 

Mark

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.