Jump to content
Security Warehouse Support Forum

Accenta Gen4 Internal Sounder Wiring


coolcreen

Recommended Posts

I have just purchased a Honeywell Accenta Gen4 intruder alarm. While the installation manual is reasonably good, the wiring of the internal sounder is unclear. My old alarm had an internal siren connected in parallel with the strobe light in the external bell box. The internal siren is polarity conscious in that it must be wired up the correct way. No problem so far.

I suppose I could connect it in the same was as it was fitted in the previous installation, but it doesn't seem quite right,

When I look at the installation, it does not make any reference to an internal siren/sounder, but it does make reference to an extension speaker (16 ohms) that may be connected across a pair of unmarked terminals and they do not give any indication of polarity markings. If I connect my present internal siren to these terminals, there is a 50% chance of connecting it the correct way,

My question is, where will I connect my ( think it is piezo-type ) internal siren to the Honeywell Accenta Gen4 panel and ensure that it is polarity correct?

 

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.