Gordon Posted June 23, 2014 Share Posted June 23, 2014 I recently purchased a galaxy flex 20 and 4 DT7450-EOL motion sensors. I wired the sensor according to the instruction manual of the motion sensor. the fault loop to zone 1, Alarm test and tamper to zone 2. The "test" to the +12V since the flex control panel doesn't have a "remote led control". see http://rikain.com/Manuals/Intruder_alarms/Galaxy/Flex_Install%20manual.pdf page 17 for the wiring schem in the flex manual. see http://www.honeywellsecurity.com/uk/intruder/documents/CPIB_52_DT7450UK2_DT7450-EOL_TRANSITION_DN.pdf page 3 for the wiring of the sensor This doesn't seem to work. Can anybody tell if the wiring is correct? I find it odd that no connection is made on the V+ and V- of the sensor. 1 Quote Link to comment Share on other sites More sharing options...
admin Posted June 24, 2014 Share Posted June 24, 2014 you will need to give the sensor power. connect + and - to the aux power terminals in the panel Quote Link to comment Share on other sites More sharing options...
Gordon Posted July 2, 2014 Author Share Posted July 2, 2014 Thanks for the reply. It seems to be working fine now. Only thing is the zone connected to "fault" is shownieuws an exclamation mark. Is this normal? I am using a Honeywell TouchCenter keypad. Quote Link to comment Share on other sites More sharing options...
Secware_Tech6 Posted July 4, 2014 Share Posted July 4, 2014 id imagine you dont hve the right resistors in the relay Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.