MikeJ
-
Posts
0 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Posts posted by MikeJ
-
-
Hi Secware_Tech6, thanks for the reply. This problem is really frustrating me as I cannot see why it is happening. Some facts:
- Remote access was working until a few weeks ago. I had not changed anything when it then stopped working.
- Test message are still responded to in the usual way. I.e. both STATUS and INPUT 1 still receive a response.
- If the alarm is triggered the dialler does dial out, and pressing '5' appeared to acknowledge the call. I need to do it again to check, but it does appear to be 'listening' to tones.
- I haven't yet tried pressing 9 after pressing 5 to enter the remote control menu after alarm activated, but will do. This should tell me whether it is not accepting the User Code, or not listening to tones.
- The User Code does work when directly entered into the keypad on the dialler. I have tried changing the User Code, but it made no difference.
- I have checked that 'Remote Access' is enabled in settings
- I have tried calling from two mobiles on separate networks (Vodafone and Tesco/O2). No difference.
- The dialler has a Global M2M sim - multi-network so it may have changed network? Do you think that if it moved to a different network it may have caused this problem?
Thanks, Mike
-
Hi Secware_Tech6, I've tried both a mobile and landline. The V2 shows five signal bars (maximum).
-
Hi All,
I have a Pyronix V2 GSM dialler. Previously I could dial into the V2, enter the User Code, then enter the remote control menu. I have not changed any settings, but the User Code is now not being accepted when dialing in (the system voice just requests multiple times for a User Code to be entered, then it times out).
I have checked:
- The User Code still works when entered directly into the V2 using the keypad.
- Status SMS messages are still responded to in the normal manner.Any suggestions as to what the problem may be?
Many thanks in advance
Mike
V2 GSM - entering remote control menu
in Intruder Alarms
Posted
Hi Secware_Tech6,
I have triggered alarm. Once alarm call acknowledged, I could then press 9 and enter the menu, and then move around the menu using key presses. So the V2 is receiving tones okay.
Therefore I have narrowed the problem down to specifically entering the User Code - it works when entered directly via the keypad, but not when entered over the phone.
I am out of ideas why this could be. Have you ever heard of this problem before?
Thanks,
Mike