Hi Secware_Tech6,
Alarm system is a Intellisense SECURIT 800L+
It would appear that I have to have scald folding put up. Been advised to remove the bell box , to reduce the risk of it getting damaged.
I do not want to blow my ear drums out. So would this procedure be correct.
I assume I have a SAB or SCB.
Apply 9-12v (I mention 9v since I was thinking of using a PP3 battery) to
–Ve and +Ve to the bell connection in the alarm control panel ( door to alarm control panel will be open)
Connect S- and -R to assuming these are held high (12V) connect to 9-12v.
Connections in alarm panel are as follows,
ST- Strobe switched negative trigger.
S - Sounder switched negative trigger
+Ve Sounder hold off/strobe positive supply.
- Ve Sounder hold off supply & sounder tamper feed (negative)
-R Sounder tamper return. (negative)
To test to make sure when I remove the bell box, ( therefore activating the tamper) . The sounder does not go off. If I remove –R Sounder Tamper Return ( negative) the sounder should not go off. Assuming of course the tamper switch in the bell box is working OK.
Of course I will be wearing ear defenders. Just to be on the safe side.
Your advice would be greatly appreciated.