I have accenta mini gen4 with two lcd keypads Master Bedroom (part sets)and Front Door and a Simple Set reader at the Back Door.
All wired to go with front and rear contacts.
Test the system while installing.... stage by stage
Stage one: Install contacts to front and rear, wire back to panel, no tamper(s) to fiddle with
Install lcds and Simpleset,find the obligatory tamper loop lock-out on powering up. Remove three wires from both tamper ports and separate into series wiring. Power up fine... disable alarm at MB RKP. Power and day lights ok. and back downstairs Front door RKP as MB Power and Day lights Okay.
Back Door Simple Set Power Light no other Lights. Offered it a Fob dull tone and error light (Four x Fob's)... internet/ Simple Set Reader / Learning Fob's when none are known: Powered down put in the link, Powered up reset MB RKP learnt the Fob's. Powered down; removed the link tightened RKP Powered up reset alarm.
Back downstairs Simple Set Reader has Power but NO Day Mode. Does not recognise Fob's. Other RKP's are fine, look to the internet again, maybe it's the single key setting? FD RKP engineers code flag single Key: yes....
Power Powered down put in the link, Powered up reset MB RKP learnt the Fob's. Powered down; removed the link tightened RKP Powered up reset alarm...
No difference
Look to internet again... the instruction for learning fobs when none are known..... does not say power down to remove link...
Well that is why I am now here in your space
Should I remove the link live I Did not think so
I would like to get on to Stage Two: Which is opening the back/front door. to create an alarm
I would like to get on to Stage Three: Which is adding bell boxes front and rear
I would like to get on to Stage Four and tackle the Pir Zones and the series wiring of all those tamper cables.
I would like to get on.... without hitting it hard