Jump to content
Security Warehouse Support Forum

Euro 46 Bell Fuse Fault - Blowing Fuses


SITS

Recommended Posts

Hi all I'm new to this forum, so please excuse my lack of technical knowledge. A couple of days ago I was moving stuff around under my staircase where I have an Alarm panel covered inside its metal casing. I'm certain I did not touch it, suddenly the house alarm went off and the Keypad panel was showing Bell fuse fault. I went ahead and replaced the bell fuse and it but it kept blowing. I had the alarm engineer who installed it come round and he disconnected all wiring to the PCB and still fuse kept blowing. The engineer has currently rewired the bell box to another connection on the PCB allowing me to still set the alarm but I have to say 'yes' to the fault to get to the zone settings. Anyone had experience of this or might be able to advise. My thinking is that there is a PCB fault.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.